im putting the new tail light in my bike wondering if anyone has done this and is familiar with how to hook up the resistors.

i found a good website but im still not sure how to do it

http://www.hooliganbiketech.net/hondacbr1000rrweb/1000RR_mods/1000RR_integratedtail/integratedtail.htm



Thank You

I have fitted this and would say not to worry about the resistors....extra weight, especially if you go for led fronts and need to fit resistors there as well.

wire the light direcly in and same with fronts, then replace the standard indicator relay with the lower flash rate one...jobs a goodun!
:thumbsup:

look at this diagram off of speedy's site. the is what you need to do.

http://www.hooliganbiketech.net/hondacbr1000rrweb/1000RR_mods/1000RR_integratedtail/wiringdiagrampowersinks.htm

You follow Speedy's in depth instructions and you won't have any problems. The only problem I faced was heat. All they tell you about mounting the resistors is not to place them near plastic, Hell, thats half of our bike. Beware of the heat and you will be fine.