This may be a stupid question, but I have to get it cleared up. I have made my decesion, and these are the performance mods I am going to make to my bike:

1. Full Akro exhaust system
2. K&N Air filter
3. PC3r with custom map
4. Scotts Steering Damper

My question is this: If I put a full exhaust on, will "rejetting" be necessary. I know that when you make performance mods on older bikes, this is necessary. I am under the assumption that since the bike is fuel injected, the PC will take care of this.

My be a stupid question, but I'm not an expert and I just need to make sure before I invest my money.

No jets to change with fuel injection. Get everything but the filter, stay with oem. weeeeeee

actually everything ive read says the oem air filters produce more hp than the k+n
the akra should net you 10-15 with a custom map unless your bike is naturally high stock according to what ive read and seen of dyno numbers, make sure you post back with your info when you get that5 shit worked out
BLING

SIG TEST

wrong forum pip sqweek. weeee

do you know who your talking to? BOW DOWN AND FORSAKE ALL OTHER BEFORE ME

A full Akro race system will work fine and its a few hundred bucks cheaper..
and the Scotts is a good idea..the PC you should wait on,try the bike first and if it runs like shit then get a PC..like they said,still with the OEM filter..

Yeah....what Stunna said!!

I posted the custom map I had for my full Akra Evo here in the tech section and I do believe it works with the race system too... if you go the pc route

Thanks for the input guys. This forum FUCKIN' rocks :!: :!: :!: