Alright guys, I need your help.

I have just bought an undetail and I can't get the fuckin' blinkers on it to work.

On the undertail, there are two wires, RED and BLACK. OK I'm not that stupid, I know the RED is power and BLACK is ground. How in the hell do I splice the wires without fucking anything up?

On the stock blinkers, as I'm sure you all know, the left side has a green and orange wire, and on the left it is green and blue.

I'm under the impression that the green is the power for both blinkers. I don't have instructions with my undertail and I hate ELECTRICAL modifications, One fuck up and you could fry your whole system.

What I did was hook up the RED wire from the undertail to the green wire on the stock blinkers. Trying to get a ground, I connected the black to a Bolt on the frame and nothing. I tried a few different combinations, including just hooking up the RED to green, and Black to the orange.

I can't get these damn things to work. I'm sure many of you have done this, how should I splice these wires to get these damn things to work.

Thanks for the input guys.

green is ground and the orange and blue wires are the positives.. You Need to hook the left red wire up to the orange positive the right red to the blue and the left black to the green wire in the same loom as the orange and the right black to the green with the blue to close the circuit or the directionals won't work.

You might want to try testing the directionals with a 1 amp battery charger to see if the bulbs are fine.

THANKS :D

It worked like a charm.

YW :D :D :D