tools needed:

5mm hex wrench
30mm 1/2" drive socket
32mm 1/2" drive socket
1/2" drive breaker bar



this is one of them times that you install off of prior wrenching experience instead or reading the instructions in the maunal
http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0164.JPG



because the manual is a mini novel!

http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0165.JPG

just like that on all 6 pages, but there is one bit of info I thought was worth sharing

(click on the pic to enlarge it if needed)

http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0168.JPG (http://gntbldr.com/coppermine/albums/userpics/DSCN0168.JPG)



unpackage the stabalizer
http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0161.JPG




remove the tank cover bolts

http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0077.JPG







then remove the 30mm stem nut
turn the bars all the way to the left

http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0162.JPG




there should be the 30mm stem nut, stem plug, and a washer

http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0163.JPG











now with the base plate,
I put the base plate adjusters both flush on the outside with the base plate
(two little hex screws as you see in the pic)
http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0169.JPG







next set down the washer on the stem to be ontop of the base plate and use the 32mm stem nut GPR provided and tighten down with having the handlebars turned now to the right.

http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0170.JPG


http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0171.JPG





now bolt down the bracket ontop of the tank cover using the bolts provided

http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0172.JPG







next set the stabalizer into the base and bolt it down with the bolts provided

http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0173.JPG







and lastly tighten the bracket pinch bolt that the stabalizer's arm goes into and your are done


http://gntbldr.com/coppermine/albums/userpics/normal_DSCN0175.JPG